|
Houston Instrument DMP-160 Series Plotters (DMP-161, DMP-162, and DMP-162R)
TECHNICAL SPECIFICATIONS |
||
|
Power Requirements
|
||
|
AC Line Voltage Selection 100 VAC 120 VAC 220 VAC 240 VAC Line Frequency Maximum Power Requirement Filtration (built-in) |
Range 83-108 108-130 183-238 216-260 48-62 Hz 85 Volt Amps EMI/RFI |
Fuse(s) T 1.25 A T 1.25 A T 0.6 A x 2 T 0.6 A x 2 |
|
RS-232C Serial Interface
|
||
|
Connector Baud Rates Handshaking Data Bits Parity Bit Input Stop Bits Output Stop Bits |
DB-25 P 2400, 9600, 19.2K, 38.4K hardware (RTD/DTR) or software (XON/XOFF) 7 or 8 odd, even, none, mark 1 or more 2 or more |
|
|
Memory (RAM)
|
||
|
DMP-161 DMP-162 DMP-162R |
Standard 512 kilobytes 512 kilobytes 1 megabyte |
Optional 1, 2.5, 4 megabytes 1, 2.5, 4 megabytes 2.5, 4 megabytes |
|
Primary Emulations
|
||
|
DM/PL and SCAN CAD HP-GL HP-GL/2 |
DMP-60 Series plotters HP DraftMaster RX emulation of 7585B plotter HP DraftMaster RX 7595B plotter |
|
|
Performance
|
||
|
Maximum Velocity (diagonal, pen up or down) Pen Carriage Media Maximum Acceleration (diagonal, pen up or down) Pen Carriage Media Accuracy Repeatability (same pen) Mechanical Resolution Addressable Resolution |
45 ips (1143 mm/s) 45 ips (1143 mm/s) 5.7 g 5.7 g 0.2% of move or 0.01 inch (0.254 mm), whichever is greater, on double-matte polyester (3 mil) at 18°C +0.002 inch (0.050 mm) 0.0005 inch (0.0127 mm) 0.001 inch, 0.005 inch, 0.025 mm, or 0.1 mm |
|
|
Environment
|
||
|
Storage Temperature Humidity Operating Temperature Humidity Note: Some media have a more restricted temperature/humidity range than the plotter. |
-40 to 140°F (-40 to 60°C) 0 to 90% RH (non-condensing) 40 to 95°F (4.4 to 35°C) 20 to 80% RH (non-condensing) |
|
|
Media Handling
|
||
|
Media Width DMP-161 DMP-162 DMP-162R Recommended Sheet Lengths Maximum Detectable Length |
Minimum 11 in (279 mm) 11 in (279 mm) 11 in (279 mm) 8 to 50 inches (203 to 1270 mm) 20 feet (6 m) |
Maximum 24 in (610 mm) 36 in (915 mm) 36 in (915 mm) |